|
|
Modeller Build Logs
SAS Land Rover 110 DPV |
| By James Wechsler | | Started: | Sep 26, 2007 | | Updated: | Feb 9, 2008 |
|
When Paul asked if any one was interested in writing a blog, I offered but my requirement was no more Shermans! Instead I proposed this project because I thought it would be an interesting subject and I haven’t seen a blog of a wheeled vehicle for some time.
The Land Rover 110 DPV is the most current version of the famous SAS Land Rovers that include the more well known ‘Pink Panther’. This version is based on the Defender 110 commercial Land Rover. It is still in service with the SAS seeing action in both Afghanistan and Iraq along with other not named place around the world.
The build will use the following kits:
Accurate Armour LR009 SAS Land Rover 110 DPV
Accurate Armour FS11 SAS 110 DPV Crew Set #1
For reference, I’ve found a few photos on the internet and in some publications but the main source is this new book:
Military Land Rover, Development and in Service, Pat Ware, ISBN 0711031894, from Ian Allan Publishing
This is a new book that covers all of the Land Rovers in military service and is quite detailed and well written. A must for all Land Rover enthusiasts.
In addition, I spent some time in a commercial version of the Defender 110 this summer and took a lot of notes on some of the details. It may not seem it, but it’s a pretty large vehicle, bigger than most SUVs but a bit smaller than a HUMVEE. |
|
|
|
| Cab Details | Nov 23, 2007 |
The details on the cab are quite good but I had a hard time figuring out where they all went because the resolution of the photos in the instructions isn’t high enough. If anyone from Accurate Armour is reading this, I strongly recommend you fix this since it becomes a more and more noticeable problem as the build goes on.
I made few modifications to this section since the kit is very comprehensive. One thing I did do was rebuild the bracket that holds the small GPS? mounted just to the right of the driver’s dash board. I had some detailed photos showing the brackets and I though it would look better if I remade the mounting brackets in photoetch. But in retrospect, I think the kit part would have been just fine.
I did have to redo the steering wheel mount because I’m using the figures designed for this vehicle and no matter what I did, I couldn’t get the driver to hold the steering wheel and have it match to the mount (see the next chapter).
|
 |
|
|