|
|
Forums - Modelling / Construction |
The construction forum is for the discussion of techniques on the construction phase of AFV modelling and the tools and materials used. |
| Topics | 1893 |
| Messages | 8727 |
|
|
| Subject: | Re: question on Brummbar fighting compartment dimensions |  |
| Date: | Jun 12, 2003 |
| From: | Christophe Jacquemont | |
Dominic,
You'll have to compare both kits. Brummbar was retooled at some stage but upper hull and fenders were from the old tooling.
Jagdpanzer IV was all new tool.
Dimensions might therefore be quite different.
Cheers,
Christophe
dominic miele wrote:
> i'm curious about the lower perimeter of the brummbar's fighting compartment in proportion to that of a jagdpanzer iv. my point is, i want to replace the fenders on my DML Late Brummbar, but i dont want to buy an entire fender kit when i only need the front and rear portions. so, would it be possible to use a set tagged for a jagdpanzer iv?? a quick look at some pics suggests that the fighting compartments may have the same lower dimensions, can anyone confirm or deny this? i'm not at home to check my references, so i'm appealling to the knowledge of the forum.
> thanks for the help
> dominic |
| |
|
|
|
