|
|
Forums - Modelling / Construction |
The construction forum is for the discussion of techniques on the construction phase of AFV modelling and the tools and materials used. |
| Topics | 1893 |
| Messages | 8728 |
|
|
| Subject: | Re: Dremel - thinking of buying one |  |
| Date: | Dec 10, 2004 |
| From: | Mike Gardella | |
I had a Dremel and found it was too fast for modelling. Even with a speed controller I could not run it slow enough to prevent melting plastic. I now have a Minicraft drill which comes with a speed controller that will adjust down to a few RPMs and will accomodate any Dremel bits. Hope this helps.
Mike |
| |
|
|
 | Dremel - thinking of buying one - David Golinsky - Dec 9, 2004 |
| . . . Re: Dremel - thinking of buying one - ian sadler - Dec 10, 2004 |
| . . . . . . Re: Dremel - thinking of buying one - Mike Gardella - Dec 10, 2004 |
| . . . . . . . . . Re: Dremel - thinking of buying one - David Golinsky - Dec 10, 2004 |
| . . . . . . . . . Re: Dremel - thinking of buying one - frankforster - Jan 14, 2005 |
| . . . Re: Dremel - thinking of buying one - Greg Harker - Dec 10, 2004 |
| . . . . . . Re: Dremel - thinking of buying one - Joseph - Dec 28, 2004 |
| . . . . . . . . . Re: Dremel - thinking of buying one - Paul Roberts - Jan 2, 2005 |
| . . . . . . . . . . . . Re: Dremel - thinking of buying one - Nathan Pereira - Jan 8, 2005 |
| . . . Re: Dremel - thinking of buying one - Sean Walsh - Jan 8, 2005 |
|
|
