|
|
Forums - News / General |
For General modelling or hobby-related topics that are not covered by any other specific forum. Please keep to topics concerning the hobby. |
| Topics | 3049 |
| Messages | 23082 |
|
|
| Subject: | Re: Give us your best tip |  |
| Date: | Jan 7, 2006 |
| From: | Howard Freeman | |
I've got two tips - I was buying some cat food at the store a while back and found a small chrome metal water dish, about three inches across. I use this for my decals. If a decal breaks up or floats off the backing paper the dish is so shiny and smooth that I can use a small brush to scoot it out of the water, it will slide and not break up on any rough surface or corners.
My other tip is a real life saver, or rather a real 'Knife saver'. Most of my hobby knives are round and when put down will try and roll off the bench. I cut a short length of square section tube and push it over the handle - end furthest from the blade of course :-) This stops any rolling and saves my foot from possibly being remodelled too. |
| |
|
|
 | Give us your best tip [IMG] - Bill Goodrich - Jan 5, 2006 |
| . . . Don't buy studebaker stock.... - Kip Rudge - Jan 6, 2006 |
| . . . Re: Give us your best tip - Robert Feehan - Jan 6, 2006 |
| . . . Re: Give us your best tip - Jim Wechsler - Jan 6, 2006 |
| . . . . . . Re: Give us your best tip - Mike Gardella - Jan 6, 2006 |
| . . . . . . . . . Re: Give us your best tip - Jim Wechsler - Jan 6, 2006 |
| . . . . . . . . . . . . $.10 Airbrush holder for Iwata's - Gary Cunningham - Jan 6, 2006 |
| . . . . . . . . . . . . . . . FREE airbrush holder - Kurt Laughlin - Jan 7, 2006 |
| . . . Re: Give us your best tip - Howard Freeman - Jan 7, 2006 |
| . . . . . . Get the right tool for the job - Kurt Laughlin - Jan 7, 2006 |
|
|
