|
|
Forums - Site / Gallery |
Messages in this Gallery forum are automatically posted when new Gallery entries are added. Other modellers can then comment on them. |
| Topics | 3578 |
| Messages | 20950 |
|
|
| Subject: | Re: how have you done ?!!! |  |
| Date: | Sep 17, 2007 |
| From: | Paul Ramsden | |
If I was to start it again I would begin with the Mouse Armour Series 11A vietnam conversion set as this has good wheels and the correct front bumper. At this address.
http://www.mheaust.com.au/MHE/Resin/MA/MALR.htm
The front mud gaurds are simply cut away with a saw and the sloping section is a piece of plasticard.
The chassis is just shortened to the correct length as was the exhaust.
The most difficult section is the rear ammo racks. I did this by cutting off the rear of the body and building the new curved sections from an old coke tin. This required lots of filler and was a bit fiddly. You also need to cut a slot in the bulkhead behind the front seats for the front gun wheel to fit through.
The rear seats are just made out of putty on a peice of plastic card.
good luck
Paul |
| |
|
|
|
